Could need simple reprogramming fix shown here.
07 ranger door glass not working on switch.
You can check the switch with a multimeter for continuity.
I was in a hurry and just wanted to get the window up so i took the battery out of my sons power wheel took off the door panel and wired that 12v battery up to the regulator directly.
Car demonstrated is 2006 mazda 3 but similar proc.
Put it back into the door panel and test the window.
The opposite could be true as well the window would close fine but does not open like normal.
So i tested both door switches and they are good so i took out the radio and checked wires on the gem module to see if i could fix the dome light issue and f.
Unplug the switch and plug in a new unit.
The most likely cause of your problem is the master switch in the drivers door.
When the system is working properly the light lets you know that one or more of your doors is either open or not closed securely.
The windows and the locks are on two separate circuits.
The only part that these two have in common is the master switch.
The switch could be dying but has not fully gone out yet.
Repair this by removing the door panel turn the armrest bolts and door handle screws counterclockwise then disengage the pop rivets and removing the motor by unplugging it along with the mount bolts.
They just pop out of the door panel openings.
Their engineers and designers carry everything you need to make your vehicle s doors operate and look as new.
Check the fuse which should be in the dashboard or under the hood check the owner s manual.
Just take a look at our wide selection of the ford ranger doors delivered from the major players in the business among which we can notice goodmark and replace.
First i took the switch off and used sandpaper on the contacts because the drivers switch contacts were pretty bad.
On some vehicles the trunk lid rear hatch and even the hood can be part of the system.
Most cars today have a door ajar warning light on their dashboards.
It should make a beep when you press the switch put the black and red on the two contacts on the switch.
When you open a window fine but it doesn t seem to close properly this could be a window power switch issue.
If there is only one window with a problem you may have a bad motor or switch.
But the warning light system can sometimes malfunction.