It is an unregulated 2a power supply.
12v led power supply circuit.
If you want to power one or more ics then it needs to be regulated with a resistor zener or better a 7805 regulator.
3 high volts power supply circuits ideas.
The most straightforward way to force a 12v led strip to work in a 24v system is to split a 12v led strip into two identical 12v led strip segments and connect the copper pads in series such that the sum of the voltages adds up to the 24v supplied by the power source.
Sometimes the voltage to drive a specific circuit is already known and power supply circuit to output a constant voltage needs to be designed.
The input to the bridge in both circuits is only about 15vac due to that.
It is a high power of 80w to 200w.
But for lighting leds etc it will do.
First power supply circuit is built with bd139 one zener diode and a few passive components.
Of course the output is not regulated and will vary a volt around 12v as the mains varies.
Connect the positive terminal of the 12 volt power supply to one side of the resistor.
Iled is the desired current through the led.
Connect the other side of the resistor to the anode of the led.
Each of the schematic is very simple to construct and will function without problems if you respect the maximum power supply ratings.
We can improve a ripple to lower.
Check the led data sheet to identify the anode and cathode.
As per the datasheet of the 5mm white led the forward voltage of the led is 3 6v and the forward current of the led is 30ma.
Here are 4 simple 12v power supply circuits with output voltages around 12v.
Low dropout the input voltage can be as little as 0 6 volts higher than the output voltage.
The cathode is commonly the shorter lead and located nearest any flat side of the led.
Therefore vs 12v vled 3 6v and iled 30ma.
In our simple led circuit consisting of a single led we have used a 5mm white led and a power supply of 12v.
The regulated 12v output from this 12v led backpack power supply circuit can be seen connected with an extra separate socket so that the user is able to access the voltage for powering any other desired 12v gadget through the same.
November 22 2019 today my son builds a simple 12 volt power supply circuit for a 12v solar pump.
Consistent led performance with any power supply and led s costs about 1 only 4 simple parts to connect efficiency can be over 90 with proper led and power supply selection can handle lots of power 20 amps or more no problem.
12v dc power supply schematics.
Forwards switching regulator circuit of 80 to 200 watts.
5v to 12v boost converter circuit or higher using transistor.
The circuit needs to be designed in a way that it should be void of any fluctuations or ripples.